Weiwei Shi recently submitted a dissertation, '˜Tree Inspired Water Harvesting,' to the faculty of the Virginia Polytechnic Institute and State University. In this study, Shi and a research team developed unique devices inspired by redwood trees, meant to efficiently harvest water.
With the use of fog harps (devices that look like harps but collect moisture droplets from fog), floating leaves, and synthetic trees, the researchers aimed to refine efficiency in aerodynamics, deposition, and sliding for water harvesting. The fog harps were made of a vertical set of wires, similar to redwood trees, able to manipulate fog droplets easily, whether '˜capturing' or '˜shedding.' Such devices can be used in areas with water shortages and little rainfall, set up to harvest condensation from fog. Typical areas where these might be used include Chile, Peru, South Africa.
'œWater shortage is a global problem. More than four billion people do not have enough water for at least one month of the year; five hundred million of them lack enough water throughout the entire year. Fog harvesting is a helpful technique to collect water from fog,' stated Shi. 'œIn California's coastal redwood forests, approximately 34% of the annual water input was from fog drip off the redwoods themselves.'
Synthetic trees were created with nanoporous disks representing leaves and tubes acting as xylem conduits, all in an effort to re-create the redwood, and its expeditious transpiration process. Harps consisting of micrometric wires were able to harvest fog droplets without clogging; in fact, they offered a '˜three-fold enhancement' in comparison to the use of traditional mesh netting.
Stainless steel nuts placed on the threaded rods of the new harps provided extra space between the top and bottom of the frame, with two 3D printed parts snapped on the top and bottom halves, sprayed with Rust-Oleum. Droplets fell into a reservoir for collecting water, with the upper piece of the harp directing fog away.
'œFor the classical mesh design, the mid-sized mesh (M2) harvested about 1.7 times more water compared to the fine mesh (M1) and 1.5 times more than the coarse mesh (M3). This is due to the aforementioned dual constraints of clogging for fine meshes and inefficient fog capture for coarse meshes,' explained Shi.
'œThe harp's ability to avoid clogging even at small scales is due to the reduced pinning force of droplets shedding parallel to the axis of the wires, compared to a mesh where orthogonal wires impede the contact line. This is somewhat analogous to the well-known case of droplets easily sliding parallel to superhydrophobic grooves, as both cases exhibit only liquid-air interfaces between the axial features and avoid any obstacles orthogonal to the receding contact line.'
'œThe floating leaf was tested within an environmental chamber with controlled ambient humidities, the synthetic stomata optionally atop the floating leaf. The leaf can 'œtranspire' stably in a wide variety of ambient humidities, even without the stomata, because the water menisci would partially retreat into nanopores to choke the vapor inside, thus increasing the local relative humidity right above the menisci,' stated Shi.
The synthetic tree will also be accompanied by a '˜tree on a chip,' along with a glass roof to be bonded over the face of microchannels.
'œFurther, a resistive heat source will be thermally lumped to this tree-on-a-chip to dramatically vary the transpiration rate, and by extension, the magnitude of the negative Laplace pressure within the system,' concluded Shi.
Water shortages continue to plague developing countries, and researchers around the world have created numerous 3D printed devices, from those meant to test potability, purification, and even filter saltwater.
What do you think of this news? Let us know your thoughts! Join the discussion of this and other 3D printing topics at 3DPrintBoard.com.[Source / Images: '˜Tree Inspired Water Harvesting']